Trusted Local Concrete Professionals in Garner
Garner is the far end of our service area, about 50 minutes from Wilson, and we take work there on projects worth the trip: full driveway replacements, patios and outdoor living space, shop and garage slabs, and commercial pads. We will tell you honestly at the estimate whether your job is one we are the right fit for at that distance.
Concrete work in Garner, on the west edge of our area
Garner is a mix of decades. The streets around downtown, Vandora Springs and Forest Hills have mid-century houses with original concrete that is thin, unreinforced and finally giving up. Out along Timber Drive, Adams Point and toward Auburn and 42, the housing is newer and the issues are fill settlement and slabs poured to minimum spec.
This is also the most piedmont ground we work in. The clay here holds water, swells and shrinks, and it moves more than the sandy loam we deal with closer to home. That means base preparation, drainage and joint layout all carry more weight, and we plan them accordingly.
- Free on-site estimates in Garner for projects in our range
- Wake County and town of Garner permits handled where required
- Piedmont clay subgrade excavated and stone base compacted
- Full driveway replacement and widening
- Patios, extensions and outdoor living space
- Garage, shop and commercial slabs
Every service we offer in Garner
Each one links to that service in Garner, priced and poured by the same crew.
Concrete DrivewaysNew driveways, extensions and aprons formed, reinforced and finished to carry daily traffic.In Garner
Concrete PatiosPatios and extensions poured flat, drained away from the house and finished to spec.In Garner
Concrete Sidewalks & WalkwaysFront walks, side paths and connectors laid out straight with joints cut before they crack.In Garner
Stamped & Decorative ConcreteStamped patterns and integral or broadcast color, picked from real samples at the estimate.In Garner
Concrete Foundations & SlabsFootings, foundations and slabs on grade over a compacted stone base, with steel sized to the load.In Garner
Garage Floor ConcreteGarage slabs poured level to the door, with joints placed to control where movement goes.In Garner
Concrete Floor InstallationInterior floors for shops, additions and outbuildings, screeded flat and finished smooth.In Garner
Concrete Pool DecksPool surrounds with slip-resistant finishes and drainage pitched away from the water.In Garner
Concrete StepsPoured steps and landings formed to an even rise and run, tied into the walk or the porch.In Garner
Concrete Parking LotsCommercial pads, lots and drive lanes built for truck loads and laid out for drainage.In Garner
Foundation RaisingSettled foundations and slabs lifted back to level, with the cause addressed before the repair.In Garner
Concrete CuttingSaw cutting and removal for doorways, trenches, plumbing runs and section replacement.In Garner
Concrete Repair and ReplacementCracked, settled or spalling concrete assessed first, then repaired or replaced with a reason given.In Garner
What we get called for most in Garner
Clay that moves with the seasons
Piedmont clay swells when it is saturated and shrinks in a dry spell, and it does that under the edge of a slab more than under the middle. Without excavation and a compacted stone base to spread the load, that seasonal movement is exactly what puts a long crack down the middle of a driveway.
Mid-century slabs at the end of their run
Around downtown, Vandora Springs and Forest Hills, the original concrete is 50 to 70 years old, poured thin, often without steel. Surfaces are spalling and panels have moved. Repairs on those slabs come back within a season because there is nothing sound to tie into.
Runoff on sloped lots
Garner has more grade than most of our area, so water moves fast and concentrates at the bottom of a lot. Driveways on a slope channel it, undercut their own edges, and dump it at the garage. We set cross fall, and add a trench drain or a channel drain where the slope leaves no other option.
What the ground and the weather do to concrete here
These are the four things that decide how we build a slab in Garner. Figures are typical for the area and are confirmed on site before we quote.
The town we are pouring in
Garner sits just southeast of Raleigh and has been absorbed into the Triangle without losing its own downtown. The result is neighborhoods from every decade since the fifties, each with its own concrete vintage and its own set of problems.
This is the western edge of our range, so we are selective. For a full driveway, a patio project, a garage or shop slab or a commercial pad, the trip makes sense and we will give you the same price structure as a job closer to home. For a small patch we will usually tell you a local crew is a better answer.
The ground is the real difference here. We are used to sandy loam over clay, and Garner is clay with grade on top of it. Both the base work and the drainage plan get more attention on these jobs than they would twenty miles east.
What Garner customers say
Pouring across Garner and the streets around it
From the older streets around downtown and Vandora Springs out to Adams Point, Auburn and the newer subdivisions along 70 and 42.
Concrete questions from Garner
Yes, for projects worth the trip: full driveways, patios, garage and shop slabs, and commercial pads. It is about 50 minutes from our base in Wilson. For a small patch or a single panel we will tell you straight that a closer crew makes more sense for you.
Need a concrete professional in Garner?
Tell us what needs pouring or replacing. We come out from Wilson, NC, walk the job, and put the number in writing the same visit.